Malco Products DHT1 Door Hemming Tool
You looking to find the "Malco Products DHT1 Door Hemming Tool" Good news! You can purchase Malco Products DHT1 Door Hemming Tool with secure price and compare to view update price on this product. And deals on this product is available only for limited time.Price:
Product Feature
- Hem door skins with speed and precision
- Attaches to standard corded or cordless drill
- Will not mar or scratch door skin finish
- Resistant to solvents
- Safe, controlled operation
- Attachment only (Does not include drill)
Product Description
Efficiently hem the edges of replacement door skins for passenger vehicle and light trucks with limited manual "tacking" requirements. The drive shaft of this power-assisted Turbo-X-Tool DH Hemming Attachment inserts into the chuck of a minimum 14.4 Volt cordless or maximum 7 Amp A/C drill. A telescoping clamp adjusts to fit length and width of any drill housing. The installed Hemming attachment is easily operated with one hand. Remove the old door skin and prep the door as usual. Slightly angling the upright lip of the replacement door skin with a hammer and dolly and flattening the point of entry will ensure smooth operation. for best results, keep the anvil of the Hemming Attachment flush against the outer edge and finished side of the door skin. The high impact, ABS polymer anvil will not scratch or mar the replacement door skin. A narrow seaming wheel fits flush against the anvil fence to provide a tight, clean hemmed door edge. The Malco DH Hemming Tool Attachment is resistant to solvents and is easily cleaned of the adhesive used between the door skin and panel.Malco Products DHT1 Door Hemming Tool Review
My husband and I run a Auto Body Shop and bought this to replace door skins with. It is very easy to use and the time it saves is awesome!!!Most of the consumer Reviews tell that the "Malco Products DHT1 Door Hemming Tool" are high quality item. You can read each testimony from consumers to find out cons and pros from Malco Products DHT1 Door Hemming Tool ...
No comments:
Post a Comment